# Test the audio level > Test audio shows a level meter and tells you whether Dubr hears the room clearly. Aim for a good level, not too quiet or too loud. Dubr Help Center / Setting up the booth Mac. Source: https://dubr.live/help/booth-mac/test-audio 1. On Live, choose the input, then press **Test audio**. 2. Ask someone to speak at the pulpit at their normal volume. 3. Adjust the send on the board until the meter says **Good level**: speech peaking between −18 and −6 dBFS, with the clip light off. 4. Press **Done**. - **No sound**: check the cable, the mixer send and that the right input is chosen. - **Too quiet**: turn the mixer send up. - **Too loud: clipping**: turn the send down until the red clip light stays off. - **Good, but close to clipping** still passes; bring the send down a little to leave room for a loud moment. - Inside the test, turn on **Listen** with headphones to hear exactly what Dubr hears. - The test stops after 10 minutes, and it can’t run while a service is live.