# Add a speaker’s voice > In Voices, press Add a voice. The speaker agrees first, then reads a short script for 1½ to 2 minutes. Creating the voice takes about a minute. Dubr Help Center / Voices & speakers. Source: https://dubr.live/help/voices/add-a-voice 1. Go to Voices and choose **Add a voice** (or **Add their voice** on a speaker). 2. **Consent**: enter the **Speaker name**. Turn on the consent box only after the speaker has agreed, in their own words, to have their voice used. 3. **Record**: pick the **Script language** they preach in, choose the **Input**, press **Start recording** and let them read the script aloud at a natural pace. Press **Stop** at the end. You can also **Add recordings** you already have. 4. **Create**: check the recordings, then choose **Create voice**. 5. When you see **The voice is ready**, listen to it, then choose it on Live for the next service. - Speaks more than one language? Use **Also read it in another language**. Each language becomes its own voice, so their voice sounds like them in each one (up to 3 languages). - Under a minute of reading still works, but 1½ to 2 minutes makes a closer voice. - Uploaded recordings: MP3, M4A, WAV, WebM or OGG, one speaker with little background noise, up to 4 MB in all. - **Clean background noise** is off for recordings made in Dubr. Turn it on only if a recording has room noise or hum. - Voices can’t be recorded or created while interpretation is running.