Skip to content

Test the audio level

Test audio shows a level meter and tells you whether Dubr hears the room clearly. Aim for a good level, not too quiet or too loud.

  1. On Live, choose the input, then press Test audio.
  2. Ask someone to speak at the pulpit at their normal volume.
  3. Adjust the send on the board until the meter says Good level: speech peaking between −18 and −6 dBFS, with the clip light off.
  4. Press Done.
  • No sound: check the cable, the mixer send and that the right input is chosen.
  • Too quiet: turn the mixer send up.
  • Too loud: clipping: turn the send down until the red clip light stays off.
  • Good, but close to clipping still passes; bring the send down a little to leave room for a loud moment.
  • Inside the test, turn on Listen with headphones to hear exactly what Dubr hears.
  • The test stops after 10 minutes, and it can’t run while a service is live.

Still stuck?

Ask AI answers from these articles in seconds. A person on the Dubr team reads every ticket and email.

Tickets open in your church’s web workspace. In the Mac app, use Settings → Support.